Anybody have any ideas on what's going on? I am getting this spaghetti on too many print attempts on a Bambu Lab P2S. #asknostr https://blossom.primal.net/b25569e977905ddf81e0162990707216c931a80983608...
Is that support? My printer (a kossel pro that I built) prints most things pretty well, but recently I tried printing part of a meshtastic board case.
One of the parts required support and my printer kept blobbing up while trying to do the support structures. I have always tried to do my designs to not require support, but this is someone else's .stl file.
I spent some time with an LLM doing research and it seems like there are things I can try (e.g. slow things down, make the supports have a bigger footprint, et al) to tweak in how I slice the print, but I have not had time to get back to that project.
On an unrelated note, our freeze drier decided to stop 'freezing'. We had a whole batch of bananas turn out with a chewy texture. Do you know of any good resources to troubleshoot? It sounds like the relay is clicking but the compressor is not coming on, even though it feels warm to the touch. Same model as yours, I think.
One of the parts required support and my printer kept blobbing up while trying to do the support structures. I have always tried to do my designs to not require support, but this is someone else's .stl file.
I spent some time with an LLM doing research and it seems like there are things I can try (e.g. slow things down, make the supports have a bigger footprint, et al) to tweak in how I slice the print, but I have not had time to get back to that project.
On an unrelated note, our freeze drier decided to stop 'freezing'. We had a whole batch of bananas turn out with a chewy texture. Do you know of any good resources to troubleshoot? It sounds like the relay is clicking but the compressor is not coming on, even though it feels warm to the touch. Same model as yours, I think.
1🤔1