Update: since launch and after the new update it shows continuous 30°C (maybe there has been a bug before) at the ASIC and 50°C at the voltage regulator. I therefore had to implement a small angle into the setup that the miner is not flat anymore (too much hot air in the gap) and added another small fan to blow under the circuit board - I connected the original fan to the small pwm which was still free (60 -> 50). All other specs are still the same. Today I had a peak of almost 2TH/s again (19.2W!). So yeah it’s fun and next project is already in the pipeline. 🙃