Skullvalanche on nostr

Open in Damus

Skullvalanche · 5w

Okay, I realized I needed to just clip off the bottom vertex so I could print it standing up with 45º overhangs so no supports needed! Also just reduced print time by about 2 hours. NOICE. https://...

Skullvalanche @Skullvalanche 1782538566

turns out that revision was too sharp of an overhang angle, and it was printing poorly, so I modified it again.

https://cad.onshape.com/documents/3918fc5f989c4ac16b22fd13/w/b2dc8d4f4fd28d756a8efdb3/e/f4d118f3a7df15328115a844

I have a good feeling about this one.

2

Jeff Martin · 4w

nostr:nprofile1qy2hwumn8ghj7un9d3shjtnyd968gmewwp6kyqpq8gragp20g724vah8r5wd285ukj3pm4aa5g9tlglqfp03vsvz7feqtf8sfm Cool! It's fun watching your 3D printing journey! I've done a ton of 3D printing and CAD design for it too. Let me know if you have any questions or anything. I'd be happy to help.

LovesTha🥧 · 4w

nostr:nprofile1qy2hwumn8ghj7un9d3shjtnyd968gmewwp6kyqpq8gragp20g724vah8r5wd285ukj3pm4aa5g9tlglqfp03vsvz7feqtf8sfm Are you worried about printing it that way up? That orientation puts the load onto the layer adhesion. I think it might be more optimal printed on it's side. To avoid any overhangs that ...