Around €100-€150.
Just wanna print Seedsigner cases and small junk
If you can double your budget and go up a generation that would save you a lot of pain... maybe to the Prusa MK3S or MK4 (open source hardware, made in EU and parts are generic), check your local 2nd hand marketplaces.
Owning a 3D printer is a project in itself, I would recommend starting with a working 2nd hand model and then upgrading. Spending 150 on parts for an older gen printer than is probably worth 150-200 when working doesnt sound like a good idea.
source: owned over 10 machines and fixed most of them, recently put to rest a creality cr10 after struggling to find a daughter board and specific pin and length ribbon cables for it.
Owning a 3D printer is a project in itself, I would recommend starting with a working 2nd hand model and then upgrading. Spending 150 on parts for an older gen printer than is probably worth 150-200 when working doesnt sound like a good idea.
source: owned over 10 machines and fixed most of them, recently put to rest a creality cr10 after struggling to find a daughter board and specific pin and length ribbon cables for it.
1
